HOT COILED SPRINGS

Hot-coiled springs are generally used in elevated temperatures, high load applications, in a corrosive environment. The transportation industry, Agriculture implement manufacturers, and construction equipments manufacturers are some of the largest users of the hot coiled springs.

Generally springs with bar diameter greater than 12.7mm (0.5 in.) are hot coiled. Bars of carbon or alloy steel are generally used for hot-coiled springs.(Details of material used is below) Since the material is special bar quality, hot-coiled springs are rather costly. For most hot-coiled springs, finished hardness requirement is in the range of Rockwell C 44-53.

IIS can manufacturer hot coiled springs upto 92mm or 3.62 inch wire diameter and OD 450mm or 17inches.

IIS hot coiled springs can be made from peeled & centerless ground bar test for crack in our bar crack detection machine to ensure no failure. All springs are heat treated in calibrated electric furnace with controlled temperature. Automatic Grinders allow excellent surface contact which ensure parallelism and squareness.
Hot Coiled Spring Samples
IIS hot-coiled springs initially wound to a greater length than finished length. Then they are pressed one or more times to make the specified length. Since presetting allows supporting greater loads because of residual stresses removal resulting from presetting, most hot-coiled springs are preset. Shot Peering is also done on all hot coiled springs manufactured at IIS to increase service life. Magnetic particle inspection can be carried out if required.

A clear understanding is a must, regarding the requirements of springs to avoid higher cost and optimum performance. For best material and optimum hardness, IIS should be consulted.
Automatic Pitch Control Coil Machine
50Ton Load Testing Machine
Automatic Hydraulic Grinding Machine

| Disc Springs [Disc Spring Materials] [Disc Spring Application] [Disc Spring Installation] [Symbols & Units] 
[Disc Springs Std Din] [Disc Spring Tolerances] [Ball Bearing Disc Springs] [Disc Springs Washers] [Belleville Washer] | 
| Wave Spring Washers | | Serrated Safety Washers | | Flapper Reed Valves | | Stamping Sheet Metal | | Curved Washers | 
| Spiral Power Spring | | Spiral Torsion Spring | | Hot Coiled Springs | | Coil Springs | | Compression Springs | | Torsion Springs|

Address : Plot No. A-26, Road No. 10, Wagle Industrial Estate, Thane - 400604, Maharashtra, INDIA
* Tel. : 2582 1941 / 2508 / 2581 3416 * Fax : 91-22-2582 4478
* Email : sales@internationalsprings.com